Interlogix NS3550-8T-2S User Manual - Manual (Page 467)

User’s Manual of NS3550-8T-2S
467
6.29 Ethernet Ring Protection Switching Command
ERPS Command
Description:
Invoking an administrative command for a given protection group
[fs|ms|clear] : setting or clearing an administrative command for a given group
<port> : forced a block on the ring port where this command is issued
<group_id> : protection group id
Syntax:
Erps command [fs|ms|clear] <port> <group-id>
Parameters:
fs|ms|clear : administrative commands
<port>
: Port number
<group-id> : protection group id 1 - 64
ERPS Version
Description:
Specifying protocol version for a given protection group
[v1|v2] : specifying protocol version for a given protection group
<group_id> : protection group id
Syntax:
Erps version [v1|v2] <group-id>
Parameters:
v1|v2 : ERPS protocol version to be supported
<group-id> : protection group id 1 - 64
ERPS Add
Description:
create a new ethernet ring protection group
<group-id> : protection group id
<east_port> : protection group Port 0
<west_port> : protection group Port 1, Port 1 can be 0 for sub-rings
[major|sub] : ring type i.e major-ring or sub-ring
[interconnected] : interconnection node or not
[[virtual_channel] : Virtual channel present or not
[<major-ring-id>] : major ring group Id for interconnected sub-ring
Syntax:
Erps add <group-id> <east_port> <west_port> [major|sub] [interconnected] [virtual_channel] [<major-ring-id>]
Parameters:
<group-id> : protection group id 1 - 64
<east_port> : Port 0 of a protection group
<west_port> : Port 1 of a protection group
major|sub : ring type
interconnected : Set for interconnected node
virtual_channel : Set for virtual channel
<major-ring-id> : major ring of a sub-ring, when configuring as an interconnected node
ERPS Reversion
Description:
Configuring reversion characteristics for a given node
[revertive|nonrevertive] : enabling or disabling reversion for a given group
<group_id> : protection group id