Changing presser feet – SINGER 514 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
Changing Presser Feet
1. Raise the prosser foot and make sure
the needle Is at Its highest point.
2. With youf thumb under the prosser
foot and your Index finger at the back,
tilt prosser foot away from you and
remove it.
3. Centre the new pressor foot under the
shank and hold it in position,
4. Lower die presser bar so that the
front opening in the shank fits over
the pin in the presser foot.
b. Press down on the presser foot screw
until the foot snaps into place.
Advertising