SINGER 514 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
......
WISSS^
mmF"
...........................................
--------- B 0bt ■ "
................
mmmmmmmmmmmmmm
............ :
I
........^.
BOBBIN WINDER SWITCH
ENGAGING HAND WHEEL
7. Place spool of thread on spool pin
over the spoof pin felt and lead
thread around bobbin winder tension
disc.
8. Pass thread, from the inside, through
hole in bobbin and place bobbin on
spindle.
9. Turn bobbin winderswitch clockwise
to "wind“ position, hold thread end
as shown and start the machine<
10, Cut off thread end after a few coils
have been wound on the bobbin,
11, When required amount of thread has
been wound (winding will stop when
bobbin is full), turn bobbin winder
swatch counterclockwase to “sew/“
position and cut thread.
12, Press hand wheel disc for sewing or
tighten the hand w/heel knob.
14