Darning with embroidery hoopt, Jl, j x j jl – SINGER 514 User Manual
Page 60
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
KEEPING UP APPEARANCES (Continued)
Feed Cover Needle Plate
V...
Darning with Embroidery Hoopt
Patlom Soloctor; Any setting
Fiexi-Stkch Dial: 0
stitch Width: l i l i 1 1 ^
Needle Position:
jL, j X j Jl
Stitch Length: 1-0
Feed Cover Needle Plate
No Presser Foot
Pressor Bar: Lowered
Preparation
Roniovo presser foot with shank and
attach feed cover needle plate. Instruc-
lions for changing the needle plate are
given on page 8.
1. Trim ragged edges from area to be
darned.
2. Centre worn section in embroidery
hoop.
3. Position work under needle over feed
cover plate and lower presser bar to
engage temion.
4. Hold needle thread loosely with left
hand, turn hand wheel over and draw
bobbin thread up through fabric> Hold
both thread ends and lower needle
into fabric.
B. Outline area to be darned with running
stitches for reinforcement,
6> Stitch across opening, moving hoop
under needle at a slight angle from
lower left to upper right. Keep lines of
stitching closely spaced and even in
length,
7, When opening is filled, cover area with
crosswise lines of stitching.
This method of controlling fabric move
ment with an embroidery hoop may be
used to do embroidering or mono-
gramming.
tTho Darning and Embroidery Hoop is avail
able for separate purchase at your Singer
Sewing Centro.
58