Threading the bobbin case – SINGER 514 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
Threading the Bobbin Case
1. Raise the presser foot.
2, Turn hand wheel toward you until
needle is above the presser foot,
3. Open slide plate.
4, Hold bobbin so that thread unwinds in
direction shown, and insert bobbin in
bobbin case.
6, Pull thread into notch, draw it under
tension spring, and into slot.
0. Draw about 10cm (4") of thread
diagonally across the bobbin.
7. Fully close slide plate with the thread
in slot between the needle plate and
slide plate. Make sure that needle
plate Is secure.
iíiíiíSiiiíS;:
Advertising