Removing and replacing carrying case base, Special care – SINGER 514 User Manual

Page 63

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Lubricate parts imdor bottom cover.

CAUTION: Remember to disconnect power-fine plug from electrical

supply before removing bottom cover or carrying case base.

If your machine is a portable, remove the carrying case base (as instructed

below).

# Tilt machine back and remove retaining nut from thieaded stud A, being

careful not to lose felt washer, and remove cover from imdBrsldo of machine,

# Oil places indicated Avoid getting oil on any part of motor or hook

driving belt,

# Replace bottom cover, felt washer, and retaining nut. Tighten retaining

nut with a screwdriver.

Hook Driving Boll

MOTOR REQUIRES NO lUBRICATfON

REMOVING AND REPLACING

CARRYING CASE BASE

# Turn machine so that back is

toward you. Tilt head back and
loosen and remove retaining nut in

centre,

# Set machine upright and lift up and

out of base,

# Replace machine in base, after

bottom cover has been attached,
making sure machine bed is fully
recessed.

# Turn machine so that back is

toward you; tilt back and replace

retaining nut. Tighten retaining nut
with a screvwiriver.

SPECIAL CARE

If the machine is to bo stored or before

extended periods of Inactivity, clean
and apply SINGER oil to all moving
machine connections to protect metal
parts.

ai

Advertising