Changing the light bulb, Replacing the slide plate – SINGER 514 User Manual

Page 65

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

CHANGING THE LIGHT BULB

CHANGING THE BUIB

CAUTION:

Disconnect poworU/ne

plug from eiecirica! supply before re^

moving light bulb,

0 Lower light bracket with finger grip.

Removing the Bulb:

Do not attempt to unscrew ballx Press it

up into socket and turn it in 'unlock'
direction, as shown, and withdraw.

Replacing the Bulb:

Press new bulb into socket with bulb pin

entering slot of socket, and turn it over in

lock' direction shown to lock bulb in
position. Push bracket back into recess.

This machine is designed to use a 20
watt maximum light bulb.

REPLACING THE SLIDE PLATE

You will not have any occasion to remove

the slide plate. However, if it should

accidently become disengaged from the
machine, it is easily replaced,

# F^aiso the pressor foot and the needle.

# Place slide plate in slide Vv^ay with the

front edge close to, but not covering,
the retaining spring (as shown).

# With a screwdriver, lift each end of the

spring into each of the side grooves on

the underside of the plate,

# DravsT the plate gently toward you and

fully engage the spring,

# Close slide plate.

RgpiAciNG

r m m m

plate

Lift Retaining

6 3

Advertising