Operating your sewing machine, Electric drive – SINGER 514 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Operating your sewing machine
■I
IIIIII!
Electrical Speed ContfOllcr i
POWER AND UGHT SWITCH
Before plugging in your machine, be sure
that the voltage and number of cycles
indicated on the plate under the hand
wheel conform to your electrical power
supply. .
CAUTION: Because of the up and
down movement of (he needle, you
must work carefully and watch the
sowing area when operating the
machirm. We recommend that you
switch off the power and light before
changing needles, pressor feet and
needle plates and when leaving the
machine unattended. This eliminates
the possibility of starting the machine
by accidentally pressing the speed
controller.
ELECTRIC DRIVE
# liaise the presser foot (the higher
lifting position allows placement of
bulky fabrics).
# Place material under the presser foot
and lower presser foot.
# Insert machine plug Into the recep-'
tacle at the right end of the machine,
and connect the wall plug to the
electrical outlet. Switch on the pow-^er
and light. Start the machine by
pressing down on foot controller. The
speed of the machine is regulated by
amount of pressure on foot controller.
# Practice operating machine (without
thread) until you become accustomed
to guiding material and regulating
machine speed.
NOTE: Do not operate machine wittv
out material under presser foot
as this may damage the feed
and presser foot.
10