Removing and replacing bobbin case, Removing face plate, Replacing face plate – SINGER 514 User Manual
Page 64
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CARING FOR YOUR MACHINE (Continued)
Raise Pm$m Foot
and Neodfe
•V
locking Pin
Position Plate
Removing and Replacing
Bobbin Case
# liaise the presser foot,
# Tufii hand wheel toward you until
needle is above the presser foot,
# Remove needle plate as instructed on
page 8.
# Remove bobbin.
To remove bobbin case, turn bobbin case
holder to back as far as it \Aall go. Lift out
bobbin case.
To replace bobbin case, guide the forked
end under the feed and then draw the
bobbin case under the position plate
as illustrated. Turn holder all the vs^ay
forward to lock bobbin case in position.
After locking bobbin case in position
check that bobbin case is not jammed
but has slight rotational movement.
# Replace bobbin in bobbin case,
« Replace needle plate.
# Fully close slide plate to lower the
needle plate locking pin and secure
the needle plate.
Arn'T Top
Cover
Face Plato
Removing Face Plate
# t,oosen and remove screw and remove
face plate by sliding it downward.
Replacing Face Plate
# Slide face plate up so that rim is
engaged under edge of arm top cover,
# Align screw hole at lower edge of
plate with screw hole in machine and
replace and tighten screv/.
62