Darts, Darts in interfacing, Iiip – SINGER 514 User Manual
Page 41
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
DARTS
Darts can be made in the usual way on
your sewing machine.
Begin stitching at the wide end of the
dart reversing if suitable as you would at
the end of a seam. Stitch to the point and
either reverse for 9mm (I'") or tie the ends
of the thread depending on the thickness
of your fabric.
PiexhStitch Dial: 0
Stitcf) Width: I И
Neodfo Position;
^
X 1 ^
*
.
^
Stitch Length: To suit fabric
Pressure: To suit fabric
Tension: To suit fabric
General Purpose or Straight Stitch
Presser Foot
General Purpose or Straight Stitch
Noedfo Plate
DARTS IN INTERFACING
Pattern Sofeotor: §
F/exhStftch Dial: 0
'If
Stitch Widti):
Needle Position:
I
X '
Stitch length: To suit fabric
Pressure: To suit fabric
Tension: To suit fabric
General Purpose Prosser Foot
General Purpose Needle Plate
interfacings can be shaped without bulk
with zig-zag stitching.
Make a test sample to determine whether
plain zig-zag or multi-stitch zig-zag best
suits your purpose.
1. Cut out the dart allowance on the
stitching line.
2. Bring raw edges together and pin
over a muslin slay*
3. Stitch, backstitching at both ends.
IIIP
ei REOU
DftRTB
STEFS IN MAKING A
DART IN INTERFACING
Step 3
39