To reassemble the needle thread tension – SINGER 15-90 User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TO REASSEMBLE THE
NEEDLE THREAD TENSION
Replace the face plate, insert the tension releasing
pin in the stud, place the thread guard plate on the
23
F
ig
. 23. R
eassembling
and
R
eplacing
the
T
ension
stud, being sure that the lug M, Fig. 22 engages
the short recess P to prevent the plate from turn
ing on the stud. Next, place the two tension discs
H on the stud, having the flat thread-bearing sides
of the discs together. Replace the indicator G with
the large open side facing end of stud so that the
plus and minus signs will be readily seen from a
sewing position as shown in Fig. 23. Insert the ten
sion spring F in the indicator so that the first half
turn F2 of this spring will straddle the lower half of
the tension stud. Guide the stop washer D onto the
stud so that the extension S will be above the ten
sion stud as shown in Fig. 23.
N O T E ;
If
the
spring and s t o p
washer are in cor
rect position, the
extension will clear
the
first
h a l f -
coil of the spring,
as shown in Fig. 24.
Next place the
numbered dial on
the stud so that the
numeral 2 is oppo
£
/
90*8
F
ig
. 24