To attach the ruffler, To adjust the ruffler for gathering – SINGER 15-90 User Manual
Page 59
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TO ATTACH THE RUFFLER
(1) Raise the needle to its highest point.
(2) Loosen the presser foot thumb screw and attach
the ruffler to the presser bar in place of the
presser foot, at the same time placing the fork
arm B astride the needle clamp.
(3)
See that the needle enters the center of the needle
hole in the ruffler.
57
F
ig
.
61.
G
athering
with
the
R
uffler
TO ADJUST THE RUFFLER FOR GATHERING
(1) Swing the adjusting finger F away from the needle.
(2) Raise the adjusting lever E and move it until the
p r o j e c t i o n D c a n b e e n t e r e d i n t h e slot
marked
O
O
£/00a9X
F
ig
. 62.
MATeR/AL
C
orrect
P
osition
for
M
aterial
to
be
R
uffled
(3) Insert the material to be ruffled between the two
blue blades Line 2, Fig. 62.
(4) Draw the material slightly back of the needle,
lower the presser bar and commence to sew.
(5) For fine gathering, turn the adjusting screw C
upward and shorten the stitch.
(6) For full gathering, turn the adjusting screw C
downward and lengthen the stitch.