Darning or embroidering – SINGER 15-90 User Manual
Page 34
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
32
DARNING OR EMBROIDERING
Turn the machine back on its hinges. Unscrew as
far as possible the thumb screw B, Fig. 32 which
is located in the lower end of the slot of the feed
A B
F
ig
.
32.
A
djustment
for
D
arning
or
E
mbroidering
lifting crank A, Fig. 32. The feed is thus rendered
inoperative and will not interfere with the free
movement of the work. Bring the machine forward
into place.
Move the stitch regulating lever X, Fig. 17 to
its neutral position in the center of the slot at the
front of the machine.
Remove the presser foot and let down the presser
bar lifter C, Fig. 16 to restore the tension on the
needle thread which is released when the lifter is raised.
Draw up the bobbin thread as instructed on
page 15.