Adjusting width of design, Adjusting stitch placement, Adjusting needle-thread tension – SINGER 413 User Manual
Page 30: L c r
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FLEXI-STITCH PATTERNS (Continued)
Adjusting Width of Design
Special
Stitch
Placement
Only
L c R
Special
Stitch
Placement
Only
Most Used
Setting
Adjusting Stitch Placement
Before moving needle position and stitch
width selectors make sure needle is above
fabric.
ADJUSTING WIDTH OF DESIGN
To produce a Flexi-Stitch pattern, the
stitch width selector must be moved
from the straight-stitch setting 0, to a
setting from 2 to 5. The higher the
number, the wider the stitch will be.
ADJUSTING STITCH PLACEMENT
Flexi-Stitch patterns can be sewn in
either L (left), C (center) or R (right)
needle positions. Center needle position
C is recommended.
Adjusting Needle-Thread Tension
ADJUSTING NEEDLE-THREAD
TENSION
Make a test sample with the fabric,
thread, and presser foot you plan to use
so that you can adjust tension to suit the
stitch pattern you have chosen.
For your test sample, set the tension dial
on 3 or 4. Notice the stitching; if the
fabric puckers, decrease tension by turning
the dial to a lower number. Sew at
moderate speed.
28