SINGER 413 - Manual (Page 9)

FEED-COVER THROAT PLATE
The feed-cover throat plate is used in
place of the general purpose throat plate
when fabric feeding is not desired. Use it
for button sewing (page 32) and free-
motion darning (page 52).
CHANGING THROAT PLATE
• Raise presser foot. (You do not need to
remove the foot.)
• Turn hand wheel toward you until
needle is in its highest position.
• Open slide plate with downward
finger pressure. Draw plate toward
you, opening it all the way to raise
the
throat plate locking pin and
unlock the throat plate.
• Place thumb under throat plate and
draw plate to the right to remove.
• Insert new throat plate under locking
pin and over positioning pin.
• Close slide plate to lower locking pin
and secure the throat plate.
CHANGING PRESSER FEET
The presser feet that are supplied with
your machine snap on and off a common
shank. To change the foot;
• Raise needle to its highest position and
raise the presser foot lifter.
• Press toe of presser foot upward (as
far as it will go) and then snap down
to remove the foot.
• Center the new presser foot under the
shank and lower the presser foot lifter
so that shank fits over the presser foot
pin. •
• Press down on presser-foot screw
until foot snaps into place.
Feed Cover Throat Plate
Throat Plate Positioning Pin
Changing Throat Plate
Shank
Foot
Changing Presser Foot
7