Removing covers, bobbin case and bulb, Removing cover, bobbin case, and bulb – SINGER 413 User Manual
Page 56
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

removing covers, bobbin case and bulb
CAUTION: Before removing covers, bobbin case, and light bulb,
disconnect power-line plug from electrical supply.
REMOVING AND REPLACING
TOP COVER
• To remove, loosen and re
move screws A and lift off
top cover.
• To replace, position cover
on top of machine and
replace and tighten screws
A.
REMOVING AND REPLACING
BOTTOM COVER
If your machine is a portable, remove the
carrying case base as instructed below.
• To remove, tilt machine back and
remove retaining nut B, being careful
not to lose felt washer, and remove
cover from underside of machine.
• To replace, position cover over bottom
of machine and replace felt washer and
retaining nut. Tighten retaining nut
* •
with a screwdriver.
"Tibi"
o
o
° o
•
i
o
o
•
54
REMOVING AND REPLACING
CARRYING CASE BASE
Turn machine so that back is toward
you. Tilt machine back and loosen and
remove the two screws C at the back
of base, and remove the retaining
nut B from the center.
Set machine upright and lift up and
out of base.
• Replace machine in base, after bottom
cover has been attached.
• Turn machine so that back Is toward
you; tilt back and replace screws and
retaining nut. Tighten screws and
retaining nut with a screwdriver,
REMOVING AND REPLACING
FACE PLATE
•
Loosen and remove screw D and
remove face plate by sliding it down
ward.
• Replace face plate by sliding top edge
of plate under edge of arm top cover.
• Align screw hole in plate with screw
hole in machine and replace and
tighten thumb screw D.