SINGER XL1000 Quantum - Manual (Page 27)

Problem Indicators For Utility Stitches And Pattern Sewing
If machine has not been properly set to sew the start/stop button will glow red and a problem
Indicator will appear in LCD window advising where problem is located.
Note: When foot speed controller Is plugged in start/stop swich will glow red until controller is
depressed.
What to do when problem indicator
appears:
Choose from the following options:
1. Correct the problem (original screen will return)
Example:
2. Press
OK indicating you understand the problem.
Then correct the problem.
3. Press which indicates you reguire help to
correct the problem.
4. If you do nothing, after a short time, the problem
indication message will disappear.
i Lower buttonhole lever.
slower buttonhole lever,
♦Buttonhole lever has not been
pulled down.
o
BBSS Bobbin winding shaft. p——
Bobbin winding shaft
was left in winding Lower presser foot.
OK
“ 7 position. ?
This appears when
you have tried to
press thread trimming
button with presser
foot raised.
Lift presser foot
lifter.
Select one of the
patterns shown on
screen.
Check upper thread.
OK
Upper thread has run
out or broken.
* Bobbin thread supply low.
OK
9
Thread is not in Check bobbin.
9
thread sensor guide.
This appears when
bobbin thread has
run out during sewing.
Lower buttonhole lever.
OK I
?l
Lower presser foot.
OK
7
Buttonhole lever has
not been pulled down.
In the case where you
have tried to start
embroidering with
embroidery foot
raised.
A r.v Machine does not accept
l\ this operation.
Memory error.
Memory is full.
OK
OK
This appears when
you have pressed a
key which is not
effective.
Memory error
Memory is full.
26