SINGER XL1000 Quantum - Manual (Page 76)

Embroidery Sewing Preparation
Foot Speed Controller
All embroidery sewing is done with start/stop
button.
Foot controller is inoperable during embroidery.
Fabric, thread and Needle
Material
Bobbin thread
Type of needle
To embroider difficult-to-sew
materials such as light-weight
materials and elastic materials,
adhere a piece of temporary-
sticking type of fusible
Interfacing (non-woven fabric),
using an iron (temperature:
low to medium) on wrong side
of such material.
Always use good quality thread
designed for sewing machine
embroidery.
White 100% Polyester light­
weight 80 to 100 weight.
Singer red band style 2020
size 11/80 or size 14/90.
Type of embroidery frames
Securing material in embroidery frame
Large Medium Small
e> o
•Embroidery area
24cm (length) X
13cm (width)
11.4cm (length) X
11.4cm (width) 5.5cm (length) X
5.5cm (width)
•Application: For large
designs such as
combination or
multiple hoop embroidery. For single
patterns, etc.
For small
articles (such
handkerchiefs)
and name labels.
1
Inner
frame
Frame adjusting screw
Draw marker lines on
material with assistant
marker. This aids
in centering and
squaring material
in frame.
Loosen frame adjusting
screw and place
material between inner
and outer frames so
that marker lines
align with raised marks
on frame.
Slightly tighten frame
adjusting screw and
pull material edges to
remove slack.
Once material is properly
positioned in embroidery
frame with no slack,
securely tighten frame
adjusting screw.
NOTE: Finger tighten only as over
tightening may cause stripping.
75