SINGER XL1000 Quantum - Manual (Page 92)

Listing of helpful messages
The following procedures will be displayed
on screen during embroidery process when
your machine is not properly set or you
have operated your machine wrong.
Press [ OK I key located upper right of
screen or correct problem displayed, and
initial touch-screen will return.
Press a key if you are not familiar with
correction to be taken, and brief explanation
of operation will be displayed.
In the case where bobbin winder shaft is set to
right-hand side.
o
ass Bobbin winding shaft.
a
I In the case where needle thread has run out or
sewing machine Is not properly threaded.
M Check upper thread.
In the case where bobbin thread has almost run
out during sewing.
TP"
OK
'■«' Bobbin thread supply low.
Check bobbin.
9
■
In the case where needle Is in or too close to
material when editing pattern data (rotate, move.
etc).
91
' In the case where
card loaded.
is pressed with no
' In the case where you have tried to start
embroidering with embroidery foot raised.
Lower presser foot.
[?J
' In the case where you have tried to combine
patterns more than capacity to be memorized.
0
Your selected pattern
cannot be combind.
OK
8 In case where you have tried to combine more
patterns than capacity to be memorized or In the
case where
Memory is full.
No more pattern<s) and or
letter<s) can be recalled.
OK you have
saved 40
patterns
already.
I In the case where you have designated so many
letters that exceed embroidery frame In X-axis
(portrait)
mode.
10 In the case where you have designated, under Y-axis
(landscape) mode an amount of letters that fit the
frame under
ABCC
Letters can not be placed
in X~axis order.
OK
landscape
mode, and
pressed X-axis
(portrait)
mode.
11
In the case where there is no function
corresponding to key you have pressed.
A
Machine does not accept
this operation.
OK