SINGER XL1000 Quantum - Manual (Page 94)

Mn the case where
^ needle is not at
highest location
when turning
power on.
f In the case where
' carriage moves
(This message is
given when turning
power on).
Carriage will move to starting
position.
OK
■This message is
^ given when pressing
Q key after re­
turning power on in
the event that power
has been turned
off or has failed.
Mn the case where
* you have pressed
I vEs I key to continue
sewing after
power failure.
(See page 86)
Power was interrupted
while sewing.
Continue sewing the pattern ?
YES NO
Start sewing the pattern from
interrupted point.
Press Start switch after checking
upper and bobbin thread.
OK
^In the case you
have tried to save
scanner or PC card
in fileother
than p I.
8 In the case where
you have pressed
^button.
9
In the case where
you have tried to
start embroidering
with no pattern
selected.
10 In the case where
pattern provided by
card is called up
after saved in element
memory files 2~13.
Example:
Select pattern or letters and
press TENTERJ key.
OK
Insert embroidery card No. 2.
11 In the case where
you have tried to
start embroidering
after combining
patterns without
12 In the case where
you have tried to
start embroidering
after building a
multiple hoop
embroidery design
without pressing
[W] key.
Press rcOMBI ENDJ key. Press TMULTI HOOP ENDJ key.
OK OK
*#Oln case where you
have pressed
| a - b - c |
or
or ( 6-..... I button
while embroidery
unit is attached.
Y^ln case where you
* ^ have pressed | |jg j
button while
embroidery unit
is not attached.
This function will not work when
embroidery unit is attached.
Turn off power and remove
embroidery unit.
This function will not work when
embroidery unit is not attached.
Turn off power and attach
embroidery unit.
15
In the case where
recalled pattern
exceeds size of
embroidery frame.
Touch ■'OKj key and
change to large
sized embroidery frame.
Recalled pattern exceeds size of
embroidery frame.
Touch TOKJ key and change to
large sized embroidery frame.
93