Please use following foot control – SINGER XL1000 Quantum User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Please use following foot control:
Sewing machine model number
Used with foot controller number
XL
-1000
YC-425(UL, CSA)
‘This appliance has a polarized plug (one blade wider than the other).
To reduce the risk of electric shock, this plug is intended to fit in a polarized
outlet only one way. If the plug does not fit fully in the outlet, reverse the plug.
If it still does not fit, contact a qualified electrician to install the proper outlet.
Do not modify the plug in any way.”
Be sure to turn power switch OFF before replacing
sewing machine needle, or lubricating machine.
When not in use, be sure to turn power switch OFF and
unplug machine.
Do not use thinner or other similar solvents to clean
machine.
Do not expose machine to direct sunlight or humid
atmosphere.
This sewing machine uses a micro computer and precision electronic circuits consisting of semiconductor components, so
please observe the following precautions:
•
Keep room temperature at 40°F to
100
T. If temperature of room where machine Is used is too low, machine may present
problems such as failure to reach its normal sewing speed.
•
Motor used in this sewing machine Is electronically controlled. When the machine is operated for an extended period
of time at low speed, safety device will automatically, turn machine OFF preventing motor from overheating. If motor should
stop while sewing, turn power switch OFF, and wait about 20 minutes. This will reset safety device.