Connecting machine, Running machine without foot speed controiier, Running machine – SINGER XL1000 Quantum User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connecting Machine
Push foot speed controller plug into lower receptacle at
right end of machine.
Push power cord plug (D into upper receptacle at right end
of machine. Plug @ into electric outlet.
Note:
If LCD window is too bright or dark to see the stitch patterns, adjust LCD brightness control (see page 10).
Running Machine
Power/light switch.
• When
“O”
side of power switch is pressed machine will
be turned off.
To run machine press foot speed controller. The harder you
press, the faster machine will sew.
To stop machine, remove foot from controller.
Note:
Power switch must be on before light switch will operate.
Running machine without foot speed controiier
Foot control must be unplugged for start/stop button to operate.
Start/stop button
Sewing speed lever
One press on button starts machine, and another press
stops machine.
Explanation of color arrow mark on start/stop button.
Green: Conditions are correct for sewing.
Red:
Conditions are not correct for sewing.
Orange:Welcome screen Is illuminated or bobbin winding shaft is in winding position.
Note:
#
1
. When foot speed controller is plugged in, start/stop button can only be used to stop machine.
#2. When foot speed controller Is plugged in, lever serves as a top speed limiter.
#3. When foot speed controller is plugged in green arrow will only glow when controller is depressed.