ADLINK cPCI-9116 - Manual (Page 73)

C++ Library
• 63
Trig_pol: trigger polarity setting:
RISE_TRIG (or 0): rising edge trigger
FALL_TRIG (or 1): falling edge trigger
Timebase_sel: Timebase source selection. Refer to 5.1.3.1 for
details.
INT_TIMEBASE (or 0): internal timebase (24MHz)
EXT_TIMEBASE (or 1): external timebase from
pin45
Delay_src: Delay source selection in delay-trigger mode.
Refer to 5.1.3.3 for details.
0: delay in timebase
1:
delay in samples
retrig_en: Enable/disable re-trigger mode acquisition when
post-trigger or delay-trigger mode is selected.
0: disable re-trigger
1:
enable re-trigger
M_enable: Enable/disable M_enable bit when pre-trigger or
middle-trigger mode is selected. Mode acquisition
when post-trigger or delay-trigger is selected.
Refer to 5.1.3.3 (pre-trigger & middle-trigger
section) for definition of M_enable
0: set M_enable to 0
1:
set M_enable to 1
ACQ_enable: Set to 0 for proper operation
@ Return Code
ERR_NoError
ERR_BoardNoInit