Echelon Lumewave CRD 3000 Street Light Bridge - Manual (Page 116)

106 Interoperable Interface for the Street Light Bridge
Variable Description Ok to Modify?
nciPriRpt Defines the repeat count for the
primary path.
Yes
See Defining the Networking
Channels on page 36 for
information about defining
channels.
nciSecChs Defines channels for RF data
transmission on the secondary
(alternate) LonTalk (ISO/IEC
14908-3) path.
Valid values are 11 to 26. Values
outside this range are ignored.
Yes
See Defining the Networking
Channels on page 36 for
information about defining
channels.
Use 0 (zero) to indicate an unused
channel.
nciSecRpt Contains the repeat count used for
the secondary path.
Yes
See Defining the Networking
Channels on page 36 for
information about defining
channels.
nciRepeatMode Defines the Street Light Bridge
repeating type:
0 – normal repeating operation
(PL and RF)
1 – PL-PL repeating (no RF
transmission)
2 – RF-RF repeating (no PL
transmission)
Yes
See Defining Repeating on page 40
for information about setting the
repeat mode.
nciMediaAccess Defines the power line media
access protocol:
0 – Default (media access protocol
is enabled during manufacturing,
based on the module model type)
1 – Normal (overrides firmware
setting and defines a PL-20N
channel)
2 – CENELEC (overrides firmware
setting and defines a PL-20C
channel)
Yes
See Defining the Media Access
Protocol on page 37 for information
about setting the media access
protocol.
Changes to this value take effect
only after a device resets.