Echelon Lumewave CRD 3000 Street Light Bridge - Manual (Page 25)

Street Light Bridge Integrator’s Guide 15
assume that the Segment Controller cannot communicate with the luminaire,
and you should proceed to step 3.
If you install the luminaires before the Segment Controller, the Segment
Controller will discover and commission all of the luminaires; however, this
process could take some time.
After an installed luminaire is discovered and commissioned by the Segment
Controller, the lamp should turn off. For any that do not turn off, proceed to Step
3 to install CRD 3000 Street Light Bridge modules; the Segment Controller will
discover the installed luminaires through the CRD 3000 Street Light Bridge
modules.
Step 3: Install CRD 3000 Street Light Bridge Modules
Install a CRD 3000 Street Light Bridge module to extend the communications
range of the Segment Controller.
Return to any previously installed luminaire for which the lamp is off (that is, it
has communications with the Segment Controller). Install the CRD 3000 Street
Light Bridge module on the luminaire or on a pole near the luminaire, and record
its physical location (GPS coordinates, pole ID, or map grid reference) and its
Neuron ID (the barcoded number printed on or attached to the module); or
alternatively, let the Segment Controller automatically discover and commission
the CRD 3000 Street Light Bridge module.
You can install the CRD 3000 Street Light Bridge module in the luminaire’s
photocell receptor after removing the photocell. For luminaraires that do not
have a photocell receptor, you need to add a locking-type photocontrol receptacle
that conforms to the ANSI C136.10 standard. 6 Insert the module into the
photocell receptor or locking-type photocontrol receptacle, and turn the module ¼
turn clockwise to lock it into position.
The CRD 3000 Street Light Bridge module has a green LED to indicate that it is
receiving power. In addition, if this LED is on solid, the CRD 3000 Street Light
Bridge module has been discovered and commissioned by the Segment Controller;
if this LED is flashing slowly, the CRD 3000 Street Light Bridge module has not
yet been commissioned.
Install a second CRD 3000 Street Light Bridge module on a luminaire (or on a
nearby pole) for which the lamp is on (that is, the luminaire does not have
communications with the Segment Controller). This second CRD 3000 Street
Light Bridge module should have direct line-of-sight with the previously installed
CRD 3000 Street Light Bridge module. Ensure that the two modules are within
85 meters (275 feet) of one another.
Verify that the newly installed CRD 3000 Street Light Bridge module’s amber
LED is on to indicate that the module has good radio frequency (RF)
communication with a previously installed module; see Verifying Successful
Installation on page 17. If the newly installed CRD 3000 Street Light Bridge
module does not have a sufficient RF signal with a nearby CRD 3000 Street Light
Bridge module, reinstall the CRD 3000 Street Light Bridge module in a different
6 Locking-type photocontrol receptacles are available from companies such as Ripley Lighting
Controls (for example, their 5927 or 5926 Receptacle With Cast Housing can accommodate the
Street Light Bridge module).