Echelon Lumewave CRD 3000 Street Light Bridge - Manual (Page 58)

48 Managing a Street Lighting Network
Manually Installing a Street Lighting Network
You can manually install a street lighting network using the Segment Controller
Web pages (see Automatically Discovering Devices on page 27 for information
about installing devices automatically). The installer should create a device list
that accurately records the device location (such as light pole number) and the
Neuron ID of the device installed at that location. For example, the installer can
peel a bar code sticker off the device and record its location next to the bar code,
or just record the device location and the Neuron ID. With the Segment
Controller Web pages, the network installation includes the following steps,
which are each described in the subsequent sections:
1. Create the devices.
2. Manually enter the locations and Neuron IDs of the devices to be
installed.
3. Select the devices to be installed.
4. Enable smart network management for the selected devices. After smart
network management is enabled, the Segment Controller automatically
loads, commissions, and sets the devices online. You can then check the
installation status using the LON Command Queue Web page.
Creating Devices
To create a device, perform the following steps:
1. Expand the Net network, right-click the LON channel, and select Add
Device from the shortcut menu to open the Add Device dialog.
2. Enter the following device properties:
• The name of the device (for example, “Oak Creek Road Lamp 46N”)