Echelon Lumewave CRD 3000 Street Light Bridge - Manual (Page 63)

Street Light Bridge Integrator’s Guide 53
Clear Table Clears all entries in the LON Command Queue table. The table
automatically re-lists pending commands (STATUS_REQUEST)
and updates their statuses after the commands successfully
complete or fail.
Configure
Device
Opens the Driver or General properties page for the selected
device.
Cancel
Command
Cancels the selected command and deletes it from the table. You
can select multiple commands by clicking one, holding down
CTRL, and clicking the other commands to cancel. You can also
use this option to delete inactive commands from the table.
Troubleshooting Street Lighting Network
Installation
If a device is not installed by the Segment Controller even after the entire
network installation has been completed, it is likely that the device has failed or
the Segment Controller cannot reach it through a repeating device. In this case,
you can do the following:
1. Add another device (such as a CRD 3000 Street Light Bridge module) at
an intermediate spot on the network that will serve only as a repeater.
See Adding Devices on page 64 for more information about adding devices
to an installed power line repeating network.
2. Replace the device to determine if it has failed. See Replacing Devices on
page 68 for more information about replacing devices on a power line
repeating network.
Maintaining a Street Lighting Network
You can perform routine maintenance to update, repair, and optimize an
installed street lighting network. You can use the Segment Controller to
maintain the network and its devices. For example, if a device fails, you can
replace it on the physical network and then logically replace it on the Segment
Controller, preserving the device’s configuration.
This section describes the following network maintenance tasks that you can
perform with the Segment Controller:
• Analyze the power line repeating network using the Power Line
Repeating Analysis Web page
• Adding devices
• Upgrade devices
• Replace devices
• Decommission devices
• Set devices offline
• Test (query and wink) devices