EXFO IQS-12002B Calibration System - Manual (Page 18)

Getting Started with Your Calibration System
14 IQS-12002B
Inserting and Removing Test Modules
2. Place your fingers underneath the module or hold it by the retaining
screw knob (NOT by the connector) and pull it out.
3. Cover empty slots with the supplied protective covers. Simply slide the
top of the protective cover into the upper grooves of the unit, and then
snap into place by pushing the retaining screw knob.
C
AUTION
Pulling out a module by a connector could seriously damage both
the module and connector. Always pull out a module by the
retaining screw knob.
C
AUTION
Failure to reinstall protective covers over empty slots will result in
ventilation problems.
YES
NO
Retaining screw
knob
Connector