EXFO IQS-12002B Calibration System - Manual (Page 83)

Calibration System 79
B Configuring the FTB-7000D
OTDR on the IQS-12002B
Test equipment is configured at the factory before shipping. The
procedures presented in this document address the case when the
IQS-12002B detects a new instrument or when a particular instrument has
not been configured.
Note: The given instructions are for the singlemode FTB-7000D OTDR; however,
you can use the same procedures for the multimode model (lengths,
tolerances, and uncertainties can differ).
The following table shows the list of calibration instruments and standards
for the singlemode and the multimode OTDRs.
Calibration Instruments and Standards
for Singlemode OTDR
Calibration Instruments and Standards
for Multimode OTDR
GP-121311: 4.4-km fiber spool GP-121492: 1-km multimode fiber spool
GP-121317: 17.6-km fiber spool GP-121490: 4-km multimode fiber spool
IQS-3100BW Variable Attenuator IQS-3100B-D Variable Attenuator
GP-121723: 50-m launch fiber Useless for multimode calibration
GP-121392: distance reference standard GP-121489: multimode distance reference
standard
GP-121310: singlemode front-connector
position (for UPC connectors)
GP-121487: multimode front-connector
position (for UPC connectors)
GP-120963: singlemode dead zone GP-121200: multimode dead zone
GP-121310: singlemode front-connector
position (for APC connectors)
GP-121487: multimode front-connector
position (for APC connectors)