Vortech 2005-2009 Ford 4.6L 3V Mustang GT - Manual (Page 14)

P/N: 8N020-120
© 2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured.
23SEPT08v3.0(8N..120v3.0)MaxflowPwrClr
4
F. Remove the 3.5" plastic idler retainer and washer.
Carefully reposition the idler and its two spacers
to the lower mounting hole just below its current
position. Reinstall the retainer previously removed
and tighten. (See Fig. 2-c.)
G. Install the five 3/8-16 x 1.0" bolts and washers
through the back side of the mounting plate.
H. Attach the supercharger assembly to the mount-
ing plate using the previously installed hardware.
A 9/16" ratcheting end wrench will greatly aid this
step.
I. Secure the oil drain hose to the installed brass fit-
ting in the oil pan, making sure to route in a
smooth downward manner away from moving or
hot objects.
J. Attach the -4 oil feed hose to the straight -4 fitting
installed in the supercharger. Secure away from
moving or hot objects.
K. Using a 1/2" ratchet, rotate the factory spring ten-
sioner clockwise and install the accessory drive
belt. (See Fig. 2-d for proper belt routing.)
NOTE: Any dips, “uphill” sections, kinks or restric-
tions may cause drainage problems and pos-
sible supercharger failure.
2. SUPERCHARGER RECLOCKING AND REINSTALLATION, CONT’D
Fig. 2-b
Fig. 2-c
IDLER
RETAINER
MOVE IDLER
TO LOWER
MOUNTING HOLE
SUPERCHARGER
HARDWARE