Vortech 2005-2009 Ford 4.6L 3V Mustang GT - Manual (Page 19)

P/N: 8N020-120
© 2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured.
23SEPT08v3.0(8N..120v3.0)MaxflowPwrClr
9
3B. WATER COOLER ASSEMBLY INSTALLATION
NOTE: Leave these screws loose for adjustment
when attaching the assembly to the vehicle.
NOTE: Refer to Fig. 3B-q for standard H.O. and 3B-r
for V-Power throughout the following steps:
1. Locate the water cooler assembly 8N106-135.
2. Install the two mounting brackets 8N010-171 and
8N010-173 to the water cooler using the supplied
1/4-20 x 1/2" screws, washers. (See Fig. 3B-a.)
3. Remove four nylon push pins from the styrofoam
bumper support and set the support and the pins
aside to be reinstalled. (See Fig. 3B-b.)
4. Remove six of the eight 13mm headed inset bolts
retaining the metal bumper support. (See Fig.
3B-c.)
5. Replace the bolts previously removed with the six
8mm x 1.25" x 35mm long bolts and washers pro-
vided.
6. Install the four 2A017-036 spacers (two each side)
onto the bolts that will secure the water cooler.
(See Fig. 3B-d.)
Fig. 3B-d
Fig. 3B-c
Fig. 3B-b
Fig. 3B-a
SPACERS
PROVIDED
13mm HEADED
BOLTS
NYLON PUSH
PINS