Vortech 2005-2009 Ford 4.6L 3V Mustang GT User Manual
Page 32
P/N: 8N020-120
© 2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured.
23SEPT08v3.0(8N..120v3.0)MaxflowPwrClr
22
Fig. 3E-d
Fig. 3E-e
10mm
HEADED
BOLT
RESERVOIR
BRACKET
Fig. 3E-f
3/4" HOSE ATTACHED
TO FACTORY 1" HOSE
Fig. 3E-g
3E. ENGINE COOLANT RESERVOIR INSTALLATION (2007 - 2008 MODELS ONLY), CONT’D
5.
Remove the 10mm headed bolt that secures the
back of the ECU and the power distribution box.
(See Fig. 3E-d.)
6.
Install the coolant reservoir. Secure the front of
the reservoir with the factory fastener removed
previously. (See Fig. 3E-e.)
7.
Attach the rear mounting bracket with the surge
tank mounting bracket to the strut tower using the
factory strut mounting hardware. (See Fig. 3E-f.)
8.
Attach a length of 3/4" hose (approximately 22"
long) to the 3/4" bung on the front of the coolant
reservoir. Secure using one of the #10 hose
clamps provided. Route the open end of the hose
to the 1" hose previously connected to the factory
coolant reservoir. Connect and secure the two
hoses using the 3/4" x 1" hose union, the factory
1" spring clamp and the #10 hose clamp provided.
NOTE: Leave this bolt loose for final adjustment in a
later step.
SURGE
TANK
RESERVOIR
BRACKET
COOLANT
RESERVOIR