Vortech 2005-2009 Ford 4.6L 3V Mustang GT - Manual (Page 22)

P/N: 8N020-120
© 2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured.
23SEPT08v3.0(8N..120v3.0)MaxflowPwrClr
12
3B. WATER COOLER ASSEMBLY INSTALLATION, CONT’D
Fig. 3B-j Viewed From Below
17. Locate the 3/4" x 150° molded rubber hose
(7U038-150). Connect the short end of the 3/4" x
150° hose to the lower port on the previously
installed water cooler. Install one of the provided
3/4" hose unions into the open end of the 150°
hose. Attach a length of 3/4" hose approximately
24" between tthe hose union and the previously
installed water pump discharge. Secure all hose
connections using the nylon ratchet clamps pro-
vided. (See Fig. 3B-j.)
18. Attach a length of 3/4" hose approximatelly 48"
long to the previously installed water pump feed
port and secure. Route the open end of the
installed hose toward the passenger’s side shock
tower. This hose will be connnected in later step.
(See Fig. 3B-h.)
WATER COOLER
HOSE TO
WATER
PUMP
3/4" x 150°
HOSE (7U038-
150)
3/4" HOSE
UNION
FRONT OF VEHICLE
NOTE: The installation of this hose section should
maintain an “uphill” routing wthout dips or
kinks.