Vortech 2005-2009 Ford 4.6L 3V Mustang GT - Manual (Page 38)

P/N: 8N020-120
© 2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured.
23SEPT08v3.0(8N..120v3.0)MaxflowPwrClr
28
Fig. 3I-a
3I. COMPRESSOR BYPASS VALVE ASSEMBLY INSTALLATION (HO KITS ONLY)
A. Assemble the bypass using a piece of 1"
hose cut to 11" long and a piece cut to 13"
long and four #16 hose clamps.
B. Attach the 11" piece of hose to the inlet of
the bypass and secure with a clamp.
C. Secure the 13" piece to the outlet of the
valve, securing it with a clamp. (See Fig.
3I-a.)
D. Attach the bypass assembly to the charge
cooler. The 11" long piece will be attached
to the charge cooler. Secure with clamps.
Leave the 13" long section open for future
attachment to the air inlet.
11" x 1" HOSE Ø
(TRIM TO FIT)
TO DISCHARGE
TUBE
13" x 1" HOSE Ø
(TRIM TO FIT)
TO MANIFOLD PRESSURE/VACUUM
#16 HOSE CLAMPS
BYPASS
VALVE
TO INLET
DUCT
E. Attach a length of 5/32" vacuum hose to the
bypass valve and route to the vacuum port
of the fuel rail sensor.
F. Re-attach the vacuum hose from the
bypass valve to the TEE.