Vortech 2005-2009 Ford 4.6L 3V Mustang GT User Manual
Page 28
P/N: 8N020-120
© 2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured.
23SEPT08v3.0(8N..120v3.0)MaxflowPwrClr
18
Fig. 3C-d
Fig. 3C-e
10mm
HEADED
BOLT
RESERVOIR
BRACKET
Fig. 3C-f
FACTORY
GROUND
STRAP
3/4" HOSE ATTACHED
TO THERMOSTAT
HOUSING
Fig. 3C-g
3C. ENGINE COOLANT RESERVOIR INSTALLATION (2005-2006 MODELS ONLY)
NOTE: Reinstall the factory ground wire with one of
the 6mm screws and washers.
5.
Remove the 10mm headed bolt that secures the
back of the ECU and the power distribution box.
(See Fig. 3C-d.)
6.
Install the coolant reservoir. Secure the front of
the reservoir with the factory fastener removed
previously. (See Fig.
3C-e.)
7.
Attach the rear mounting bracket with the surge
tank mounting bracket to the strut tower with the
6mm x 20mm long screws and washer provided.
(See Fig. 3C-f.)
NOTE: Leave this bolt loose for final adjustment in a
later step.
8.
Attach a length of 3/4" hose (approximately 3'
long) to the 3/4" bung on the front of the coolant
reservoir. Route the hose to the 3/4" outlet on the
thermostat housing secure the hose with the
clamps provided. (See Fig. 3C-g.)