Kirby Sentria - Manual (Page 17)

16
Canister Cleaner & Attachments
PART THREE
Your Kirby® Sentria® system comes with a wide variety of
attachments for added versatility. In this section, we will
discuss the following:
Removing the Power Nozzle to Convert to a
Canister Cleaner
Using the Attachments
Using the Suction Control Grip
Using as a Blower Unit
Using the Portable Sprayer and the
Portable Shampooer
CONVERTING TO A CANISTER CLEANER/
INSTALLING THE ATTACHMENT HOSE
When using different cleaning attachments, the Attachment Hose is
connected to the front of the cleaner in place of the Power Nozzle  25 .
NOTE: When connecting the Attachment Hose, you may choose
between the Upright Handle  17 or the Portable Handle  15 . To install
the Portable Handle, see page 14.
To install the Attachment Hose, you must first convert to a Canister
by removing the Power Nozzle. To do so, press the Toe-Touch
Control Bottom Pedal  9 all the way down until nozzle is fully raised.
Disengage Tech Drive® power assist by stepping on the gray “N”
side (marked “N” for Neutral) of the Tech Drive N/D Pedal  11 .
Turn the Sentria® system OFF by pressing the Power Switch  13
and then unplugging. ➤
Raise the Headlight Hood  21 and flip out the handle on the Belt
Lifter  20 . Use it to turn the Belt Lifter all the way to the left
(counter-clockwise) until the red arrows line up.
Unlock the Power Nozzle by turning the Accessory Lock  22 all
the way to the left (counter-clockwise). The Power Nozzle should
tip forward when it is released. Lift the nozzle away from the
Sentria system. ➤
1
2
3