Kirby Sentria - Manual (Page 28)

27
CARPET SHAMPOO SYSTEM SET-UP (cont)
Taking care to avoid spilling liquid on the Sentria® system or
the floor, place the opening in the bottom front of the Shampoo
Tank over the Air Exhaust Port  19 on the unit. Angle the Shampoo
Tank outward from the unit until the arrows line up. Next, slide the
Shampoo Tank down over the locking pins on the Air Exhaust Port.
Rotate the Shampoo Tank toward the unit (clockwise) to lock it
in place. ➤
Push the round elbow of the small flexible hose into the hole in the
tray until it snaps into place. Firmly insert the other end over the
fitting at the bottom front of the Shampoo Tank. ❏
USING THE CARPET SHAMPOO SYSTEM
To set the nozzle to the proper height, step on the Toe-Touch
Control Upper Pedal  8 as often as necessary to lower the nozzle
to its lowest position. ➤
NOTE: Forcing the brushroll into the surface of the carpet decreases its
ability to thoroughly clean the carpet and could damage the belt
and brushroll.
Turn the Suds Control Valve all the way to the right (clockwise)
to the ON position. Turn the Sentria system ON and engage
Tech Drive® power assist (see page 7 for details). Suds flow will
begin immediately.
Turning the valve all the way to the left (counter-clockwise) to the OFF
position will stop the flow of suds completely.
Stopping the flow of suds allows you to thoroughly brush all the suds
into the carpet before applying more suds. This also lets you spot scrub
badly soiled areas. ➤
Optional Accessories
9
8
1
2