Kirby Sentria - Manual (Page 32)

31
REPLACING A WORN CARPET SHAMPOO
SYSTEM NOZZLE BELT
To replace the Carpet Shampoo System Nozzle Belt, push the
thumb pads located at each end of the shield and rotate the shield
up and away from the brush. ➤
Push down carefully on the ends of the brush with your thumbs.
The brush will snap out and the belt can be replaced.
Be certain the belt is placed in the center of the brush. NOTE: Use only
approved Kirby® belts. ➤
2
1
Align the metal ends of the brush with the slots on the tray and
push the brush in until it snaps into place. The brush will only fit
the tray the correct way.
NOTE: The belt should not be stretched when stored for an extended
period. Make sure the green arrows line up for storage. ❏
3
Optional Accessories