Kirby Sentria - Manual (Page 35)

34
CAUTION: To avoid loss of control, do not stand unit on end for polishing. The
Tech Drive pedal must be in the neutral position during polishing.
FLOOR BUFFER SET-UP
Your Sentria® system can be used as an effective floor buffer for
wood or tile floors.
To use the Floor Buffer, you must first insert the Buffer Brush into
the Floor Buffer Nozzle.
Center the belt of the Buffer Brush in the middle area between
the tufts of the brush. ➤
Turn the Buffer Nozzle over and slide the ends of the Brush into
the slots at each end of the nozzle. The Buffer Brush will only fit
the correct way. ➤
Push the belt up against the Brush Roll with your finger. ➤
While holding the belt in place, use the handle on the Belt Lifter to
turn it left (counter-clockwise) until the red arrows line up. The Belt
Lifter hook will catch the belt and stretch it upward into the nozzle. ➤
1
2
3
4
Optional Accessories
!
Place the hooks located on the rear of the nozzle over the Attaching
Bar  24 and push the nozzle up against the Sentria® system.
Turn the Accessory Lock  22 all the way to the right (clockwise) to lock
the nozzle in place. ➤
5