Kirby Sentria - Manual (Page 34)

33
KIRBY MIRACLE WAX DIRECTIONS
For Hardwood, Vinyl, Cork and Linoleum Floors:
1. Clean surface thoroughly.
2. Attach Kirby Floor Care System Buffer Nozzle and
Brush according to the instructions on page 34,
under ‘‘Floor Buffer Set-Up.”
3. For best results, apply a very thin coat of Kirby
Miracle Wax using the roller applicator. It is not
necessary to completely cover the floor with wax at
this time, as the wax will be spread in the next step.
4. Using the Toe-Touch Control Upper Pedal to lower the
nozzle all the way down, spread the wax evenly over
the entire floor using the Kirby Floor Care System
Buffer Brush.
5. Let dry 5 minutes.
6. When dry, buff with the Kirby Floor Care System
Buffer Brush.
NOTE: For very worn areas, two coats may be re quired.
In this case, multiple thin coats will provide better
results than one thick coat.
For Marble Floors:
Apply a thin coat and spread as in the directions in #4.
However, buff immediately, avoiding any drying time.
Once you have completed the steps above, the floor
may be rebuffed, any time it becomes necessary, using
the Floor Care System Buffer Brush. Apply additional
wax ONLY when rebuffing does not produce
acceptable results.
IMPORTANT:
Do not use Kirby Miracle Wax on rubber
or asphalt tile. ❏
If desired, prepare the long waxer roller handle for storage by
depressing the spring-loaded pin on the lower portion of the handle
while pushing the upper portion toward the hooked end.
IMPORTANT: Seal used roller in original packing bag and tube after
each use to prevent the wax from drying out. ❏
Grasp both the packing bag and roller firmly and pull them off the
long roller waxer handle. To do this, push the roller away from the
handle grip toward the bar to compress the retaining spring. This will
allow you to slide the roller over the end cap. Seal bag tightly to prevent
premature drying. Store in the provided packing tube and put in a safe
place away from children and pets until next use. ➤
5
Optional Accessories
USING THE MIRACLE WAXER®
FLOOR POLISHER (cont)
To remove the wax roller from the long handle, hold the original
wax roller packing bag with the open end facing the roller.
Push the wax roller into the packing bag as far as it will go.
Avoid touching the wax with your hand. ➤
4
6