Kirby Sentria - Manual (Page 30)

29
CLEANING THE CARPET SHAMPOO SYSTEM (cont)
Turn the Accessory Lock  22 to the left (counter-clockwise). The
Carpet Shampoo System Nozzle/Tray Assembly will tip forward.
Lift the Nozzle/Tray Assembly off the Sentria® system and carry it
to the sink. ➤
Remove the hose from the tray and rinse. ➤
By using the handle, turn the Belt Lifter to the right (clockwise)
until the green arrows line up. Pull the tray and nozzle apart.
Rinse tray. ➤
To clean the brush, push the thumb pads located at each end of the
plastic shield and rotate the shield up and away from the brush.
Disconnect the shield by gently pulling out the ends of the tray just
behind the Brush Roll.
Push the Brush Roll down out of the tray by simultaneously pushing
on both ends of the brush with both thumbs.
Rinse all areas of the shield tray and brush, and remove any lint
from brush tufts.
Shake excess water from the Brush Roll by brushing hand over
the bristles and then drying with a towel. ➤
Optional Accessories
5
4
6
7