Kirby Sentria - Manual (Page 38)

37
CAUTION:
Be sure no metal objects, such as tacks, nails, etc., are sticking up from the
surface. They can damage the sandpaper and the Turbo Accessory. They
may also cause sparks, which could ignite dust. Replace the disposable bag
after extended sanding because the dust is fine and will plug the bag pores.
Select the correct grade of sandpaper needed for the job. Use fine
paper for a smooth finish and coarse paper to clear rough surfaces
or remove paint.
Slide the sheet into the front clamp and lock the clamp lever.
NOTE: Three grades of sandpaper come with the Sander.
Each piece is a standard ¹/
3
sheet. ➤
Tightly wrap the paper around the bottom of the Turbo Accessory
and tuck the end into the rear clamp. Lock the rear clamp. ➤
With the Turbo Accessory on a level surface, wrap the Sander
Dust Shroud around the Sander with the opening to the rear and
snap it closed. ➤
!
TURBO ACCESSORY SET-UP
The Turbo Accessory System can be used for a wide variety of household
jobs. It’s a sander, a buffing unit and a scouring unit.
TURBO-SANDING
To set up the Turbo Accessory System as a sander, unsnap the
Sander Dust Shroud at the rear of the tool and lift off. ➤
Rotate the clamp levers on the side of the Turbo Accessory
upwards to open the clamps. ➤
2
1
Optional Accessories
3
5
4