Kirby Sentria - Manual (Page 27)

26
CARPET SHAMPOO SYSTEM SET-UP (cont)
Press the Toe-Touch Control Bottom Pedal  9 all the way down to
raise the front of the Sentria® system. ➤
4
Optional Accessories
While sliding the Carpet Shampoo System Nozzle/Tray Assembly
toward the Sentria® system and over the Motor Shaft  23 , connect
the hooks on the bottom rear of the nozzle to the Attaching Bar 
24 . ➤
Push the nozzle up against the unit and turn the Accessory Lock  22
to the right (clockwise) to lock the nozzle in place. To engage the
belt, use the handle on the Belt Lifter to turn it all the way to the right
(clockwise) until the green arrows line up. Then lower the Headlight
Hood  21 . ➤
The Shampoo Tank is removable and should be filled or
emptied at your sink.
NOTE: The Shampoo Tank is removed and re-attached in the same
way as the Mini Em-Tor® collector (see page 9 for details).
Unscrew the large cup from the top of the Shampoo Tank and turn the
Suds Control Valve fully to the left (counter-clockwise) to OFF.
Holding the Shampoo Tank level, fill it to the full line with warm water
(not hot).
Using the large cup from the top of the tank, pour three cupfuls of
Kirby ® Carpet Shampoo into the Shampoo Tank. Do not use more,
as over-foaming will result.
NOTE: One tankful of solution will clean about a 10x12 foot carpet
(3x3.5m). Larger carpets will require refilling the Shampoo Tank.
Replace the large cup into the opening on top of the Shampoo Tank. ➤
5
6
7