Kirby Sentria - Manual (Page 25)

24
PORTABLE SHAMPOOER SET-UP (cont)
Remove the jar from the Portable Sprayer and fill the jar about 3/4
full with Kirby® Carpet Shampoo mixture (Mix according to the
instructions on the bottle.) USE ONLY KIRBY CARPET SHAMPOO
for best results. ➤
Screw the jar tightly on the Portable Sprayer, then attach the
Sprayer to the Attachment Hose.
Make certain your Sentria® system is set up as a Blower Unit. The
Attachment Hose should be connected to the side Air Exhaust Port  19 . ❏
Canister Cleaner & Attachments
2
3
IMPORTANT: The Portable Shampooer is not recommended for use on upholstery or fabrics
such as silk, brocade and velvet. If in doubt, try a test patch. Let the test patch
dry and then check it before you shampoo further.
!
USING THE PORTABLE SHAMPOOER
Before shampooing, vacuum surface thoroughly.
To make suds, turn the Sentria® system ON and pull the trigger
of the Portable Sprayer. A stream of suds will come out of the cap.
The suds can be sprayed directly onto the surface being cleaned or
on a plain paper bag or in a bowl and then applied to the surface
being cleaned. ➤
Adjust the Portable Sprayer for proper suds volume by turning the
Spray Adjustment Control located on the trigger. ➤
Work suds into the surface with a soft clean, white brush or sponge
until they disappear. Allow the surface to dry completely.
Then vacuum with the appropriate cleaning tool. This will remove the
dry residue which contains grime and loosened dirt. ❏
1
2
3