CIRCUTOR computer PLUS-TF Series - Manual (Page 38)

38
 You can browse any parameter to see how it is programmed. However, when you attempt to edit a field,
a screen will ask for the password (Fig.44). Follow the instructions described in section 7.1 to enter the
password.
 If the unit is in operation, the screen shown on Fig. 45 will appear before the setup process is carried out
and the regulator will disconnect any steps connected.
Fig.44.- Password request Fig. 45.- Setup with connected steps.
 The indispensable parameters that must be configured to start-up the Computer plus are:
 C Power kvar
 Capacitor
 V-I Connections
 Transf. Ratio
 Compensation
 Target Cos φ
 tact, trec
 Apart from the indispensable parameters shown on the previous list, Computer plus has a series of
optional parameters that do not have a direct impact on the compensation process. These parameters
are:
 Date/Time
 Display
 Communications
 Clear/Update
7.3.3
Adjusting Capacitor Power
This unit can be used to adjust the power of each capacitor step in the compensation unit.
The adjustment method is described in section 7.2.1 for the Plug&Play settings.