CIRCUTOR computer PLUS-TF Series - Manual (Page 45)

45
7.3.12 Adjusting Communication Settings
This option is used to adjust the communications parameters of channel COM1, in order to integrate
Computer plus
in a network with “Power Studio Scada”. The CPC NET channel controls the capacitors
through the CPC3i-xRS card and it can not be configured.
To adjust channel COM 1 proceed as follows:
 Open the setup menu by following the procedure described in section 7.3.2.
 Select the Communications (Fig.64) option and press
OK . The screen on Fig.65 will be displayed.
 Press
Edit to adjust the desired parameter values.
Fig. 64.- Communications Adjustment Menu Fig. 65.- Edit Communications Adjustment Menu
 The following parameters can be configured:
Perip … Adjustment of the peripheral number when Computer plus is in a network of instruments
connected to “Power Studio Scada”. Adjustable between 001 and 255
Baud …This option adjusts the communication speed (Baud rate). The options are: 9600, 19200,
38400 and 57600
Parity Adjusts the parity. The options are: None, Even, Odd
Bits … Adjusts the number of bits and Stop bits. The options are: 8bits , 1stop or 8bits , 2stop
 To edit a field, follow the procedure described in section 5.4.
7.3.13
Adjusting Clear / Update
This option can be used to delete the maximum or minimum records and enter the device's reprogramming
system.
 Open the setup menu by following the procedure described in section 7.3.2.
 Select the Clear / Update (Fig.66) option and press
OK . The screen on Fig.67 will be displayed.
 Press Edit to adjust the desired parameter values.