CIRCUTOR computer PLUS-TF Series - Manual (Page 41)

41
Fig. 50.- Transformer Ratio Fig. 51.- Edit Transformer Ratio
 Press
Edit and the screen shown on Fig.52 will be displayed. To edit a field, follow the procedure
described in section 5.4.
Fig. 52.- Transformer Ratio Menu Fig. 53.- Edit Transformer Ratio Menu
 When the adjustment is complete, press OK to display the screen shown on Fig.53, indicating the cos 
of each phase and in the header, the kvar introduced in each phase in case it is started. The menu bar
shows the options to continue editing values when you press
Edit. The unit will start-up when you press
Run . If the values measured seem correct, press Run. Otherwise, check for errors.
7.3.7 Adjusting the cos

objective
The cos

objective can be adjusted. To do so, follow this procedure:
 Open the setup menu by following the process described in section 7.3.2
 From the options menu, select Target cos φ (screen on Fig.54) and press OK . The screen shown on
Fig.55 will be displayed