d&b V-Series - Manual (Page 17)

2.9. Splay link of the frame
Splay link position
By factory default the Splay link is attached and parked to
«POSITION V8/V12».
Depending on the type of cabinet (V8/V12 or V-SUB) to be
attached to the Flying frame the position of the frame's Splay link
needs to be changed as described in the following section
Þ Changing the Splay link position.
Splay link of the frame – «POSITION V8/V12»
Splay link of the frame – «POSITION V-SUB»
Splay link park position
During transport the Splay link can be folded into its park position
and fixed using its Locking pin.
Splay link at park position – «POSITION V8/V12» Splay link at park position – «POSITION V-SUB»
Changing the Splay link position
WARNING!
Potential risk of personal injury and/or
damage to material!
The fixing bolt [B] of the frame's Splay link bears the full load of
the array.
It is essential that the bolt is fitted correctly and secured by a
locked ring cotter [C].
To change the Splay link position, proceed as follows:
d&b V-Series Rigging manual (1.9 EN) 17