Flying frame instruction label – d&b V-Series User Manual
Page 8
2.1.1. Flying frame instruction label
Pos.
Description
[2]
Center bar of the Flying frame with user instruction label.
[2.1]
Main hole grid at the top of the center bar with a total of 40 holes numbered with an increment of five. Using the V Load
and Þ Chapter 2.7. "Suspension of the Flying frame" on page 14).
[2.2a]
[2.2b]
Fixing point for the frame's Splay link in «POSITION V8/V12».
The additional hole is used to fix the Splay link at park position ( ) using the respective Locking pin (refer to Þ Chapter 2.9.
"Splay link of the frame" on page 17).
[2.3a]
[2.3b]
Fixing point for the frame's Splay link in «POSITION V-SUB».
The additional hole is used to fix the Splay link at park position ( ) using the respective Locking pin (refer to Þ Chapter 2.9.
"Splay link of the frame" on page 17).
[2.4]
Hole grid ground stack: when V8/V12 cabinets are attached to the top of the frame, this hole grid indicates the possible settings
of –7°, –3.5°, 0°, +3.5° or +7° for the Splay link of the first (bottom) cabinet (refer to Þ Chapter 3.4. "Ground stacks"
[2.5]
If the Flying frame is fitted below a V-SUB cabinet (Mixed V-Series array with V-SUB cabinets at the top of the column), these two
holes are used to fix the Rear link of the "last" V-SUB cabinet to the frame using the Locking pin of the respective cabinet and the
Locking pin of the Cable pick (refer to Þ Chapter 3.2.3. " Mixed array", Þ step " 2. Attach the assembly to the frame" on
page 28).
d&b V-Series Rigging manual (1.9 EN)
8