d&b V-Series - Manual (Page 30)

3.3. V Touring cart assembly
The V Touring cart allows for a quick and easy setup of arrays as
the entire cabinet assembly stored in the cart can be directly
connected to the V Flying frame or mounted below already
suspended V8/V12 or V-SUB cabinets.
This type of setup is also very efficient when working space is
restricted.
3.3.1. Assembly
Remarks
For the assembly the same general preparations are made as
described in .
The setup should always be carried out by two persons.
The rigging procedure described below applies to both touring
cart options.
Splay link of the frame
For this type of setup, the Splay link of the frame must be attached
to «POSITION V8/V12». Check the position and alter it if
necessary as described in Þ Chapter 2.9. " Splay link of the
frame" Þ " Changing the Splay link position" on page 17.
3.3.1.1. Cabinet assembly to Flying frame
1. Prepare the touring cart
1. Move the cart to its assembly position.
2. Unlock the four fasteners (CamLocks) on the top lid and take
off the lid.
3. Unlock the four fasteners (CamLocks) on the bottom tray and
remove the connecting poles.
Splay link of the frame – «POSITION V8/V12»
d&b V-Series Rigging manual (1.9 EN) 30